Schmid Watson Especificaciones Pagina 82
- Pagina / 134
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Watson Ethernet
Operating Manual
Watson-Ethernet-Manual.doc
Version 3.3-01
7-20
Revision: 2010-01-20
7.2.12 Spanning Tree Configuration
The Rapid Spanning Tree Protocol (RSTP) is available on the Watson Ethernet
plug-in only. The Watson Ethernet tabletop modem is transparent for spanning
tree bridge protocol data units (BPDUs) but will not interpret them.
STP
Displays the current STP configuration. Data for both the bridge and for the root
bridge are shown. The bridge is identified by its ADMIN-NAME.
LTU_01_CM> STP
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Configuration of Rapid Spanning Tree Protocol
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Spanning Tree protocol: RSTP
Topology Change Count: 0
Time Since Last Topology Change: 0 days, 0:01:11
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Bridge: Root BRIDGE-1
Bridge Priority: 32768 32768
Bridge ID: 8000-00:80:6B:6B:04:86 8000-00:80:6B:6B:04:86
Hello Time (sec): 2 2
MaxAge (sec): 20 20
Forwarding Delay (sec): 15 15
Transmit Hold Count: 6
Cost to Bridge: 0
Root Port:
Spanning Tree protocol
Currently active STP version (STP IEEE 802.1d or
RSTP IEEE 802.1w)
Topology Change Count
Number of topology changes
Time Since Last Topolo-
gy Change
Time since last topology change (days, h:m:s)
Bridge Priority
Bridge priority
Bridge ID
Bridge identifier (Bridge priority and MAC Address of
interface MGMT3)
Hello Time
Hello timer. Determines how often the bridge broad-
casts its hello message to other bridge.
MaxAge
Maximum age timer. Determines the maximum age of
a BPDU
Forwarding Delay
Forwarding delay timer. Determines (in STP mode)
the time before a port will change from learning to
listening and from listening to forwarding states
Transmit Hold Count
Transmit hold counter. The maximum number of
BPDUs transmitted per second.
Cost to Bridge
Path cost to the root bridge
Root Port
Selected root port. This is the port providing the low-
est path cost to the root bridge. Left empty on the root
bridge.
- Declaration of Conformity 3
- Limited Product Warranty 9
- Table of Contents 11
- 1 Related Documents 17
- 2 Overview 19
- 3 Modem Features 23
- 3.1.2 Multipair operation 24
- 3.1.4 Power Backoff 26
- 3.1.7 Wetting Current 28
- 3.1.8 Master / Slave 29
- 3.1.9 DSL Clocking 29
- 3.2.1 Ethernet over DSL 29
- 3.2.2 Ethernet Bridging 30
- 3.2.4 VLANs 31
- 3.2.5 VLAN Examples 31
- 3.2.7 Stacked VLANs 35
- 3.3.1 Ethernet over DSL 41
- 3.3.2 VLAN features 41
- 3.3.4 Cisco HDLC 42
- 3.4 Firmware update 43
- 3.5 Management 43
- DISCONNECT 45
- 3.7 Test loops 48
- 3.8 Password protection 49
- 4 Powering 51
- 5 LEDs and Alarms 53
- 5.2 Tabletop LEDs 54
- 5.3 Alarm Conditions 55
- 5.4 Alarm Relays 55
- 5.5 Initialization Errors 56
- 6 The Monitor 57
- 6.2 Addressing of Plug-ins 58
- 6.3 Naming of ports 59
- 6.4 Telnet Access 59
- 6.5.1 Welcome Screen 60
- 6.5.2 Menus 60
- 6.5.4 Tab completion 61
- 6.5.5 Help 61
- 6.5.6 Command History 61
- 6.5.7 Continuous Displays 62
- 7.1 Introduction 63
- 7.2.1 General Commands 64
- DEFAULT Configuration 66
- 7.3.1 Diagnostic 89
- 7.3.2 Status (Plug-in) 90
- 7.3.3 Status (Tabletop) 92
- 7.3.4 Alarms 93
- 7.3.5 Test loops 95
- 7.3.6 Reset Commands 95
- 7.4.1 G.826 Statistics 96
- 7.4.2 Ethernet Statistics 97
- 7.5.1 Connection control 100
- 7.5.2 Inventory 100
- 7.5.3 Password 101
- 7.5.4 Firmware Update 103
- 8 SNMP 105
- ENTITIY-MIB 106
- 8.1.3 SNMP Configuration 107
- 8.1.4 The Entity MIB 107
- 8.1.6 The ifTable 109
- 8.2 MIB Reference 110
- 8.2.5 RMON (RFC 2819) 111
- 8.2.6 IF MIB (RFC 2863) 111
- 8.2.11 MAU MIB (RFC 3636) 112
- 8.2.15 HDSL MIB 114
- 8.2.16 Schmid MIB 115
- 8.2.17 Watson MIB 115
- 9 Front and Rear Panels 117
- 10 Connectors and Cables 119
- 10.2 DSL Interface 121
- 10.2.2 DSL Cable 122
- 10.3 Ethernet Interface 123
- 10.4 Monitor Interface 123
- 10.5 Power and Grounding 124
- 11.1 Interfaces 127
- 11.2 Power Consumption 128
- 11.3 Ethernet 128
- 11.5 Management Functions 129
- 11.6 MTBF 129
- 11.7 Environment 130
- 12 Terminology 131
- 13 Product Order Codes 133
- Revision: 2010-01-20 134
Relacionado con productos y manuales para Redes Schmid Watson
Redes Schmid Watson Información técnica
(292 paginas)
(292 paginas)
Redes Schmid Watson Especificaciones
(103 paginas)
(103 paginas)
Redes Schmid Watson Guía de instalación
(129 paginas)
(129 paginas)
Redes Schmid Watson Especificaciones
(130 paginas)
(130 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.064 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales